The Type CV Relays are single-phase induction disc ... the relay has a low pickup value for fundamental volt- age and a much ...... Coral Springs, Florida 33065.
moisture, excessive vibration, and heat. Mount the relay vertically by means of t he four mounting holes on the flange for semi-flush mounting or by means of.
Internal Schematic of the Type CP Relay with Independent Contacts in the Type FT-11 Case. Fig. 1. Type CP ... the case by a push rod located at the bottom of the case. The front .... Set the left- hand contact back out of the way and bring the.
change taps requires connecting the lead located in front of the desired setting by means of a screw con- nection. 4.0 ENERGY REQUIREMENTS. See Table I.
and the electrical connection is made through a spiral spring fastened to the moving contact arm and frame assembly. 2.2 Indicating contactor switch (Ics).
the normal direction to hold the contacts open. ... contact must be held open until sufficient real power flows ... moving contact just makes with the right hand sta-.
The CWD relay for three-phase application, senses ... The watt sensing unit settings can be defined either by contact settings or .... Coral Springs, Florida 33065.
Of the line to WhiCh it is conneCted by pulled downward on the front contact end by a measuring the ratio of ..... verified by turning the core screw all the way in.
settings and electrical connections. APPLICATION. The KD-3 relay (Figure l) is a single phase impedance type relay connected to receive phase-to-neutral ...
ity for Class 1E application in accordance with the ABB program for Class 1 E. Qualification Testing as detailed in bulletin STR-1. The MG-6 relays are used in protective relaying or control applications where .... Coral Springs, FL 33065. Tel: +1 ..
For the type KH-2 relay with separate overcurrent unit, proceed ... The directional overcurrent unit is a product induction cylinder ..... Coral Springs, Florida 33065.
If damage is found or suspected, file a claim with the ... Always apply over-current protection on ungrounded input and output conductors as detailed in Article 450 of NFPA ... requires an ambient room temperature not to exceed 40 °C (104 °F).
The type KRQ relay is a high-speed directional over- current ground ... and the overcurrent unit operates on residual current. ..... Coral Springs, Florida 33065.
taps requires connecting the lead located in front of the tap block to the desired settings by means of a screw connection. 3.3. Indicating Contactor Switch (ICS).
ground relay in which the directional unit operates on negative sequence current and voltage, and the over-current ...... Coral Springs, Florida 33065. Telephone:.
setting is determined by the sum of per unit values between the R and L lead. ... erating torque as determined by the phase sequence ..... Stated another way, the.
600 volts maximum, AC or DC. AC use is limited to 50/60 Hertz. The tester cases and prod assemblies are designed to prevent dirt, dust, and small metal objects ...
the heating element, buy a suitable descaler and descale your kettle. After descaling ... deposit on the side of the kettle. This is normal but can be removed with.
-4° to 140°F (-20° to 60°C) ... 2. 20. 200. OHM. ND 6295-2 61-310 Instructions 1/5/09 9:35 AM Page 7 .... período de 2 años contados a partir de la fecha de.
Replacement manuals are available upon request at no charge. Do not discard this product or throw away! For recycling information, go to www.greenlee.com.
Do not operate with the case open. Failure to observe these warnings could result in severe injury or death. Electric shock hazard: Contact with live circuits could ...
